Tax season for landlords does not start in April. It ends on December 31, when the year's deductions lock. A repair paid on December 30 is a deduction on this year's return; the same repair paid on January 2 is next year's. An improvement finished and placed in service before New Year's Eve starts depreciating this year; finished a week later, it starts next year. None of this is complicated — but all of it is time-sensitive, and the work that saves money is done in November and December, not in the week the return is due.
The checklist below is ordered by what actually expires at year-end. Work through it in one or two sittings, and the return practically writes itself in April. The dollar figures use a 22% federal bracket for illustration; your bracket may differ, but the logic does not.
The checklist
| # | Item | Deadline |
|---|---|---|
| 1 | Prepay January's deductible bills | Dec 31 |
| 2 | Finish planned repairs; place improvements in service | Dec 31 |
| 3 | Close out the mileage log; record Dec 31 odometer | Dec 31 |
| 4 | Collect W-9s from every contractor paid this year | Dec 31 |
| 5 | Reconcile rent received vs. the bank deposits | Dec 31 |
| 6 | Separate security deposits from rental income | Dec 31 |
| 7 | Review depreciation: new assets, bonus depreciation, cost seg | Dec 31 |
| 8 | Check the QBI 250-hour log | Dec 31 |
| 9 | Confirm the Q4 estimated tax payment | Jan 15 |
| 10 | Send 1099-NECs to contractors | Jan 31 |
| 11 | Gather 1098s and year-end statements | Jan–Feb |
| 12 | Set the tax reserve for the April balance due | April |
1–2. Pay and finish before the cutoff
Most landlords are cash-basis taxpayers: a deduction counts in the year you pay for it. Paying January's bills in December pulls the deduction into this year. The classic candidates are the January mortgage payment (the interest portion), property insurance premiums, and any contractor invoice already in hand. Prepaying $1,800 of January expenses in December, at a 22% bracket, saves about $396 of tax this year — but be clear about what that is: timing, not new money. You get the deduction a year earlier; you do not get it twice. It is worth doing when this year is a high-income year and next year looks thinner, and it is not worth doing if next year will be the bigger year.
The same cutoff applies to work, not just payments. A repair is deductible in the year it is paid for, so a December invoice paid in December is this year's deduction. An improvement is different: it starts depreciating when it is placed in service, so a new water heater installed and working on December 28 starts its depreciation clock this year, while one installed on January 3 starts next year. If a job is already scheduled, ask the contractor whether it can be finished — not just started — before the 31st. The repair vs. improvement guide explains which side of the line each job falls on, and why the classification matters more than the timing.
The one thing to remember: December 31 is a cliff, not a guideline. Cash-basis landlords deduct what they paid this year, and improvements start depreciating when they are placed in service. Everything on this list that says "Dec 31" means the money has to move or the work has to be finished — not scheduled, not quoted, not promised.
3–4. The records that cannot be rebuilt in April
Close the mileage log. Record the odometer on December 31, add up the year's business miles, and split them at July 1 — the rate was 72.5 cents per mile for January through June and 76 cents for July through December, and the return needs the two halves separately. The mileage guide has the full table and the worked example. If the log has gaps, rebuild what you honestly can now from calendars and invoices, while the year is still fresh; in April the same reconstruction is guesswork.
Collect W-9s from every contractor you paid this year, before they disappear for the holidays. You need each contractor's name, address, and taxpayer ID number to file a 1099-NEC — and for payments made in 2026 the threshold is $2,000, up from $600. The forms themselves are not due until January 31, but the information is collected in December, when the contractor still answers the phone. The 1099 guide covers who gets a form, who is exempt (corporations, generally, are not reported), and the January 31 deadline.
5–6. Make the income number honest
Reconcile rent received against bank deposits for the full year. The number on the return is the rent you actually received, and the bank statement is the check: every deposit should match a tenant and a month, and every missing month should have a reason — a vacancy, a late payment that arrived in January, a partial payment with a plan. A month of rent that arrived on January 2 is next year's income for a cash-basis landlord, which is also a legitimate way to end the year: do not chase a December deposit just to have it count this year if the tenant is paying on their normal schedule.
While you are reconciling, separate the security deposits. A deposit you are holding is not income — it is the tenant's money until you keep some of it for damage or unpaid rent, at which point only the amount you keep becomes income. The most common bookkeeping error in this area is recording the whole deposit as rent when it arrives, which overstates income and then creates a mess when part of it is returned. The deposit deductions guide and the bookkeeping mistakes guide both cover the separation habit in detail.
7–8. The two reviews that change the return
Review depreciation before the year closes, because it is the largest non-cash deduction most landlords have and the easiest to get wrong by omission. Did you buy anything this year that should be on the depreciation schedule — an appliance, a fence, a new HVAC component? Is there a property whose land/building split was never set up properly? And is this the year for a cost segregation study, which moves 5-, 7- and 15-year property out of the 27.5-year bucket — with 100% bonus depreciation, the short-life pieces can be deducted in year one? The depreciation guide and the cost segregation guide walk through both. The study only helps if the property is placed in service and the study is done for the year you want the deduction in, so December is decision time, not April.
Check the QBI 250-hour log. The 20% Section 199A deduction for rental income is available to landlords who meet the safe harbor: 250 hours of rental services for the year, with contemporaneous records. If you are close to 250 hours, December is when the remaining hours are still earnable — a weekend of documented work at the property, with the log updated the same day, can be the difference between the deduction and no deduction. If you are nowhere near 250 hours, do not manufacture them; the QBI guide explains the test honestly, including the hours that do and do not count.
9–12. January, and the money for April
Confirm the fourth estimated tax payment, due January 15, 2027. By then you know almost the whole year's numbers, so it is the payment you can size accurately — check it against the safe harbor (100% of last year's tax, or 110% if last year's AGI was over $150,000) and top it up if you are short. The estimated tax guide has the dates, the math, and the W-2 withholding workaround that can erase a penalty even in December.
Send the 1099-NECs by January 31 to every contractor who crossed the $2,000 threshold in 2026, and gather the statements that arrive in January and February: the 1098 mortgage interest statements, the property tax bills, the insurance premium summaries. File them in the same folder as the rent roll and the mileage log, not in a drawer, because the person who prepares the return — you or your CPA — will ask for exactly these pieces, and "I think it's in the email somewhere" is how a deduction gets left off.
Finally, set the reserve. Once the year's profit is roughly known, estimate the April balance due and move it into the tax account now, while the rent is still coming in. A landlord who owes $2,000 in April and has $2,000 set aside in January has a boring April. A landlord who owes $2,000 and has to find it in April has a bad one. The reserve is the last item on the list because it depends on all the others — and because it is the one that decides how tax season feels.
Track it in one spreadsheet
The Rental Property Tracker logs rent and expenses per property, maps every expense to its Schedule E line, and prints a CPA-ready year-end summary. Start with the free one-sheet rent ledger, or get the full tracker.
Get the Tracker — $29 Free Rent Ledger (Excel)
One-time price · Excel & Google Sheets · Bundle with Airbnb module available for $49.
FAQ
Can I prepay a whole year of expenses in December to cut this year's tax?
Only expenses you actually pay, for a period that is reasonably near — the IRS applies a 12-month rule to prepaid expenses, so prepaying January's bills is fine, but prepaying a full year of insurance or a contractor's retainer for work next summer will generally not all count this year. Pay what is due soon, not what is due next fall.
What if a contractor finishes work in December but I pay in January?
For a cash-basis landlord, the deduction belongs to the year you pay, not the year the work was done — so a December job paid in January is next year's deduction. An improvement is the exception to the timing: it starts depreciating when placed in service, even if you pay for it later.
Do I need to do all 12 items if I only have one rental?
Yes, but they take less time than the list looks. A one-property landlord can work through the whole checklist in a single evening: the rent reconciliation is 12 deposits, the mileage log is one car's trips, and the contractor list is usually two or three names.
Is December too late to fix a bad year of bookkeeping?
No — December is the best time to fix it, because the records still exist and the people who can confirm them still remember. Rebuild the rent roll from bank statements, rebuild mileage from calendars and invoices, and label anything reconstructed as reconstructed. A repaired year beats a perfect-looking invented one.